2014-08-08 07:22:00
#1
I’m looking for a supplier for 16 cavity mold
hello, I’m looking for a supplier for 16 cavity mold (the part looks something like a “kinder egg”), thin walls (about 0.6 mm ,20gr), i will install a hot runner system on it. i need approx, 40-50 million a year, the supplier has to guarantee a 5 sec cycle time, i can supply a mold design and a bom later on, moldbase would be American or European standard equivalent
2014-08-08 14:19:00
Top #2
Hello Danny, When applying the Tandem Technology to your project you can get a higher production output.
2014-08-08 16:26:00
Top #3
Wilhelm, its very interesting i spent a few cups of coffee over your web site and it is impressive. basically its like sticking two separate molds back to back? accept the main center runner and mold base dimensions they do not have anything in common? and how cost effective is that? repairing and maintaining wise and when purchasing manifold for this system, when injecting the lower molds the plastic has to travel a longer way, how do you stabilizing temperature and preventing it from freeze? thanks again for the info
2014-08-08 19:13:00
Top #4
Danny,
The Tandem Technology works as if you would have 2 stand alone tool or like a stack mold except we have an alternating cycle - therefore also you do the processing as if you have 2 stand also processes, therefore each parting line has its individual profile. You can have also 2 different sized parts per parting line, meaning that the weigh difference is not an issue. You can also look each parting line individually and produce from one parting line only. By using the Tandem Technology properly you can reduce the piece price up to 40 percent. But there is far more what can be done and applied for - you can reach me and we can discuss the options.
The Tandem Technology works as if you would have 2 stand alone tool or like a stack mold except we have an alternating cycle - therefore also you do the processing as if you have 2 stand also processes, therefore each parting line has its individual profile. You can have also 2 different sized parts per parting line, meaning that the weigh difference is not an issue. You can also look each parting line individually and produce from one parting line only. By using the Tandem Technology properly you can reduce the piece price up to 40 percent. But there is far more what can be done and applied for - you can reach me and we can discuss the options.
2022-07-15 17:05:16
Top #5
Hello Danny,
If we can be of help let me know. We are very experienced in reducing cost price and cycle time based on strategic planning and design.
If we can be of help let me know. We are very experienced in reducing cost price and cycle time based on strategic planning and design.
Post a Comment: