July 14, 2022

Can you eliminate ejector pins marks?

blog mold

I am working on an air pressure expulsion mechanism for plastic injection molds, to avoid the use of ejector pins and eliminate or reduce the ejector pins marks. I would like to know other possible solutions to reduce the marks when you eject the parts from the cavity. I will appreciate your comments or ideas!

Related Blogs

types of gate in mould
Types of Gate in Mould: Selecting the Right One for Your Project
Introduction to Injection Molding and Its Significance Injection molding is one of the most important processes in the modern manufacturing sector. It is known for mass production of plastic parts...
blog aco mold
Injection mold lifter scoring
The major contribution for the lifters scoring was the load of the molded part itself. The ejector pins were not sufficient enough to eject the part out in a balanced...

Table of Contents

Tell us your request right now and contact us today about getting started on your next project together!

Email:
sales@acomold.com

Or Fill Out The Contact Form Below:

Support Your Business with Better Molding Solution

Contact Info
Copyright © 2023, ACO Mold. Terms of Service and Privacy Policy. All rights reserved.  Powered by ACO MOLD.
1 1.png

Join Our Network

Please email to sales@acomold.com
or fill out the contact form below: