Category
- Products & Services
- PO Procedure
- Buying Tips in China
- FAQ
- Contact us




(Aco Mold Co., Ltd - a good reputation company in China for custom plastic injection mold manufacturing.)
08-15-2014 11:34 下午
#1
Producing an injection moulded accessory using Rapid moulds
08-16-2014 01:45 上午
Top #2
It will be difficult to recover tooling cost at low volume. At 10K you are in the realm of AL insert for Master Unit Die at 1K the tooling costs would over inflate the piece price. Have you considered urethane castings until your ready to scale up? They make a silicone mold from a FDM or SLA part.
For the AL MUD insert Protomold is competitive and responsive. They can get your parts across the pond overnight. You will have to absorb the cost until the volumes climb.
Joe Rogers
For the AL MUD insert Protomold is competitive and responsive. They can get your parts across the pond overnight. You will have to absorb the cost until the volumes climb.
Joe Rogers
08-16-2014 04:04 上午
Top #3
Hello, Abs, we can make injection mold and part for you. my suggestion is for small quality part, you can only need the part no need the mold, let mold supplier use old mold base and local standard, so that the price will be cheaper.
08-16-2014 09:41 上午
Top #4
Hello Abs,
For small quantities, I have 3 solutions in mind to reduce your cost:
- prototype mould
- aluminium mould
- as said Lily Chang, the use of an old mould base
Good luck for your project.
Jonathan
For small quantities, I have 3 solutions in mind to reduce your cost:
- prototype mould
- aluminium mould
- as said Lily Chang, the use of an old mould base
Good luck for your project.
Jonathan
08-16-2014 12:33 下午
Top #5
Thank you all for your comments, much appreciated.
Post a Comment: