PM schedule for molds

I am tasked with looking for an economical way to schedule PM’s for around 700 molds. Most of these are very low runners mixed with finite personnel resources to perform the PM’s, make the PM frequency more difficult. What methods are being used in the industry for this scenario?

08-29-2014 05:26 上午

Top #2

Robert J. Celarec

Lief,

Seems to me there are two key elements here that you must deal with.

First, due to the infrequent use and low run time, it's obvious that the vast majority of your tool inventory remains shelved for extended time periods. This makes storage critical. Without knowing your current practice, it's hard to comment or provide advice. Maybe you can provide some additional information.

Second, it follows that some form of P.M. must be performed immediately after the mold is removed from the press. You cant let a dirty tool sit on a rack for days or weeks and not expect the gasses etc. to have caused some form of havoc, whether it be pitting or corrosion, for example.

So, what do you do today? I'm not promoting any certain system, but you may want to check out the link below for some ideas. It would be great if you could comment on your current practices so others can join the discussion and hopefully help you develop a robust PM plan.

08-29-2014 08:12 上午

Top #3

Elaine Miao

If you want to reduce cost, Please noted MS-Mold is awarded the certificate of ISO9001