Category
- Products & Services
- PO Procedure
- Buying Tips in China
- FAQ
- Contact us




(Aco Mold Co., Ltd - a good reputation company in China for custom plastic injection mold manufacturing.)
09-09-2014 10:02 AM
#1
Cooling tower, compressor and chiller for injection molding factory
09-09-2014 12:21 PM
Top #2
Hi,Mr.Bibhudatta.The size of air compressor depend of the consumption(robots,vacuum,etc.)Normally you must have a little bit more(the air flow from compressor).The chiller depend from the power of the machines,type of machines(hydraulic/electric),thermoregulators,temperature needed in injection department(in process).Normally,the companies who make these,can make the project.
09-09-2014 02:52 PM
Top #3
thanks for ur suggetion
09-09-2014 05:29 PM
Top #4
Try and contact SIAD Company from Italy. They will assist you with any of the issues that you have.
09-09-2014 08:10 PM
Top #5
HOW TO DETERMINE THE INJECTION TIME,COOLING TIME,FOR A PRODUCT THEORETICALLY,BEFORE THE TRIAL IN INJECTION MOLDING
09-09-2014 10:12 PM
Top #6
HOW TO DETERMINE THE MFI OF MATERIAL FROM THE GRADE.
09-10-2014 12:48 AM
Top #7
HOW TO SELECT THE TONNAGE FOR A PARTICULAR MOLD.
09-10-2014 03:41 AM
Top #8
Injection Time is determined by the type of material, the rate of injection utilized and the aesthetics / quality of the party being produced. The cooling time is determined by the amount of BTU's / Joules that have to be offset to get the part from a liquid ( molten plastic ) state to a solid state that is at a safe handling temperature. The MFI of the material is determine by the rheology of the material, not necessarily from the grade. Tonnage for a particular mold is determined by the projected area of the part, the type of material the part is made from and the type of injection process being used.
A mold filling / cooling computer program can give you a very sound basis for determining the answers to each of these questions.
A mold filling / cooling computer program can give you a very sound basis for determining the answers to each of these questions.
Post a Comment: